Activation Of Card Reader - Fermax LOFT Manuel D'utilisation

Activation of card reader

To activate the reader the MASTER card must be programmed. This is the card that will
serve, later, to access to the preogramming functions. The other KIT functions will be
operative even though the card reader is not activated.
The system will take as MASTER card the first one shown to it after the power has been
switched on.
1. Mark one of the cards as
MASTER. This card may not
be used as a personal card
IMPORTANT:
It is very important not to lose the MASTER card, as it will be necessary to activate or
deactivate the personal cards.
If the MASTER card is lost or needs to be replaced, it is necessary to carry out all the
steps indicated in the section "Reset of Parameters" (we recommend you entrust this
task to specialised personnel).
NOTE:
The reader returns to normal mode, from any other programming setting, if no card has
been shown within a 30 second period.
¡Beep!
2. Show the card to the
reader
-
3. The reader is now activated
and ready for operation
after activation of the
necessary personal cards
Pag 5