WALL SUPPORT
HOW TO PLACE THE WALL HOLDER
Take the wall holder set, screw out the knob widdershins to make the three components separately.
You can choose the preferred height to put the wall holder, but the minimum distance should be 20 cm from
both the ceiling and the nearest wall (horizontally).
Fix the base of wall holder by screw and then fix the wall holder to the base by the knob. (N.B.: check the
orientation, referring to the mark on the appliance).
HOW TO PLACE THE UNIT ON THE WALL HOLDER
Put the unit on the wall holder, inserting firstly the top of the back and then the bottom using
the appropriate support points.
When hang on the wall, the unit can be fixed in different positions:
- parallel to the wall;
- directed downward;
- directed downward and to the right;
- directed downward and to the left.
To adjust the direction, remove the unit from the wall, loose the knob, adjust the support in the desired
position and then secure the knob again firmly; then place again the unit on the wall.
To take out the unit from the wall holder press the small lever under the lower arm of the holder and
then pull gently the unit.
22
Solis_Smart_Heater_Betriebsanleitung.indd 22-23
REMOTE CONTROL
There are six "soft touch" keys on the remote control, which functions are exactly the same as the ones of
control panel keys.
This remote control uses lithium-manganese button battery, model no. CR2032 -3 V, compliant with New
Batteries Directive no. 2006/66/EC.
HOW TO PUT/ REMOVE BATTERY OF REMOTE CONTROL (see the picture here below)
Open the door of the battery on the back of the remote control (press the button and pull back the door).
Put the battery into the door (make sure the polarity is correct).
Insert the door to the remote control.
EU 2006/66/EC
Information for correct disposal of the battery in accordance with the European Directive
2006/66/EC
Please replace battery when its electricity charge is used up: please do not eliminate this battery together
with normal household waste. It must be taken to special local community waste collection centres or to
a dealer providing this service. Disposing of a battery separately avoids possible negative effects on the
environment and human health deriving from an inappropriate disposal and enables its components to
be recovered and recycled to obtain significant savings in energy and resources. In order to underline the
duty to dispose of this equipment separately, the battery is marked with a crossed-out dustbin.
MAINTENANCE
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING.
DO NOT IMMERSE HEATER IN WATER.
CLEANING
Clean the filter frequently, according to the environment: a dirty
filter could restrict the air flow and cause the heater to function
improperly or shut down. Pull out the filter as the direction showed
on the right.
23
08.04.10 17:16