Publicité
Les langues disponibles
Les langues disponibles
EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
_ CAREFULLY READ INSTRUCTIONS
AND KEEP FOR FUTURE USE.
THE CHILD'S SAFETY COULD BE PUT
AT RISK IF THE INSTRUCTIONS ARE NOT
FOLLOWED.
_ THIS PRODUCT IS DESIGNED FOR A
CHILD WHOSE MAXIMUM WEIGHT
IS 45 POUNDS (20 KG) AND WHOSE
MAXIMUM HEIGHT IS 43 INCHES
(110 CM). THIS SHOPPER BASKET IS
DESIGNED TO CARRY A MAXIMUM
WEIGHT OF 11 POUNDS (5 KG). ANY
CUPHOLDER EVENTUALLY PROVIDED
WITH THIS UNIT IS DESIGNED
TO CARRY A MAXIMUM WEIGHT
SPECIFIED ON THE CUPHOLDER
ITSELF. ANY POACH OR POCKET
PROVIDED WITH THIS UNIT IS
DESIGNED TO CARRY A MAXIMUM
WEIGHT OF 0.44 POUNDS (0.2 KG).
_ FAILURE TO FOLLOW
MANUFACTURER'S SPECIFICATIONS
OR USE OF ACCESSORIES OTHER
THAN THOSE APPROVED BY THE
MANUFACTURER MAY CAUSE THE
UNIT TO BECOME UNSTABLE.
_ AVOID SERIOUS INJURY FROM
FALLING OR SLIDING OUT. ALWAYS
USE COMPLETE 5 POINT SEAT BELT.
_ NEVER LEAVE YOUR CHILD
UNATTENDED.
_ ALWAYS USE ALL THE BRAKES
WHENEVER PARKED.
_ TO AVOID SERIOUS INJURY, WHEN
MAKING ADJUSTMENTS ENSURE
THE CHILD'S BODY IS CLEAR OF ALL
MOVING PARTS.
_ ALL OPERATING AND ASSEMBLY
PROCEDURES SHOULD BE
PERFORMED BY AN ADULT.
_ DO NOT LIFT THE STROLLER BY
GRIPPING THE FRONT BAR. THE
FRONT BAR IS NOT DESIGNED TO
WITHSTAND LOADS.
_ ENSURE THAT THE STROLLER IS
OPENED CORRECTLY AND LOCKED IN
POSITION OF USE.
_ CHECK TO MAKE SURE THAT THE
CAR SEAT OR THE BABY CARRIAGE
IS CORRECTLY FASTENED TO THE
STROLLER (WHERE APPLICABLE).
_ DO NOT DRIVE THIS PRODUCT
AROUND STAIRS OR STEPS; CARE
MUST BE TAKEN IF UNIT IS USED ON
STAIRS OR ESCALATORS.
_ DO NOT USE THE PRODUCT IF IT HAS
BROKEN OR MISSING PARTS.
_ DO NOT USE NEAR FIRE OR EXPOSED
FLAME.
_ NOTICE: THIS ARTICLE MEETS OR
EXCEEDS ALL REQUIREMENTS
COVERED IN ASTM F833 STANDARD
AND LATEST REVISIONS.
_ MAKE SURE THAT THE REAR LEDGE IS
ALWAYS SECURELY ATTACHED USING
THE SCREW SUPPLIED.
INSTRUCTIONS
1 OPENING THE STROLLER: (fig_a) To open the
stroller, lift the lever on the handlebar (fig_a)
until the safety hooks are unfastened; lift the
handlebar all the way up (fig_b), then push it
all the way down to the final click (fig_c).
2 FRONT WHEEL ASSEMBLY: before inserting
the wheel, straighten the footrest, insert the
nut and then insert the screws under the
footrest, tightening them to hold it in place
(fig_a). Now press the button (fig_b) and slide
the wheels on until you hear a click (fig_c),
then check that they are connected correctly
(fig_d).
3 ASSEMBLING THE BASKET: Attach the screw
and the stabilizer to the basket rod and
tighten (fig_a). Fasten the basket on the front
to the hooks (fig_b), button it on the rear and
fasten it internally to the sides (fig_d).
4 FRONT BAR-TRAY: Place and attach the front
bar-tray (fig_a). To open the front bar on
one side only, press one of the two buttons
placed underneath and turn it upwards (fig_
b). To remove it, press both buttons and pull
it upwards at the same time (fig_c). Do not
place hot drinks on the front bar-tray because
it could be dangerous.
5 HOOD: To attach the hood, insert the tabs
into the notches (fig_a) and button the hood
to the rear of the backrest (fig_b).
6 The hood can be moved to different positions
while your child is sleeping (fig_a). To remove
the hood, press the side buttons while lifting
- 11 -
Publicité
