Olympus STF-8 Mode D'emploi page 19

• While holding down the buttons on
both sides of the joint, insert the lens
ring perpendicularly all the way into the
joint so that the teeth of the joint press
against it as shown in the fi gure. Keep
the lens ring straight when inserting it.
3
Tighten the screws to secure the
joint to the lens ring.
• If you want to change the position of the
joint on the lens ring, move it along the
lens ring while holding down the buttons
on both sides of the joint.
• When detaching the joint, loosen the
screw and remove the joint from the
lens ring. Keep the joint straight while
turning the screw.
• Repeat steps 1-3 to attach the other
joint.
4
Attach the lens ring fi tted with the
joints to the lens of the camera.
• If the joints are blocked by a camera
grip or other obstacle, move the joints
while attaching the lens ring.
19
EN