Haussmann Xpert HSMS15A-10-DB Mode D'emploi page 40

OPERATING INSTRUCTIONS
Checking Right 45° Bevel Stop
1. Lower head assembly and engage head
assembly release knob (6).
2. Slide head assembly completely to the back
and tighten the slide lock (29).
3. Rotate miter table (21) to the 0° miter
position.
4. Untighten the bevel lock (16)
5. Pull out the bevel adjuster (18)
6. Tilt the saw to the right until you feel the stop
in the 45° right position. This is where the saw
is currently set for the 45° right bevel cut.
7. Use a combination square to check blade at
the 45° stop. Place the combination square
head on the miter table (21) and press it's 45°
surface against the saw blade (42). If the saw
blade does not contact the full length of the
square, follow the calibrating procedure.
Calibrating Right 45° Bevel Stop
1. Untighten the bevel lock (16)
2. Pull out the bevel adjuster (18)
3. Tilt saw to 45° right bevel position.
4. Position combination square with 45° surface
against saw blade (42).
5. Rotate 45° Bevel adjustment screw (34) while
viewing blade against combination square
until it matches 45° surface.
6. Adjust bevel scale pointer to 45° line on
bevel scale (17).
Checking left 45° Bevel Stop
1. Lower head assembly and engage head
assembly release knob (6).
EN
2. Slide head assembly completely to the back
and tighten the slide lock (29).
3. Rotate miter table (21) to the 0° miter
position.
4. Untighten the bevel lock (16)
5. Pull out the bevel adjuster (18)
6. Tilt the saw to the left until you feel the stop
in the 45° left position. This is where the saw
is currently set for the 45° left bevel cut.
7. Use a combination square to check blade at
the 45° stop. Place the combination square
head on the miter table (21) and press it's 45°
surface against the saw blade (42). If the saw
40
blade does not contact the full length of the
square, follow the calibrating procedure.
Calibrating left 45° Bevel Stop
1. Untighten the bevel lock (16)
2. Pull out the bevel adjuster (18)
3. Tilt saw to 45° left bevel position.
4. Position combination square with 45° surface
against saw blade (42).
5. Rotate 45° Bevel adjustment screw (33) while
viewing blade against combination square
until it matches 45° surface.
6. Adjust bevel scale pointer to 45° line on
bevel scale (17).
Clamp assembly
The clamp assembly (10) can be mounted to
the fence, either side of the saw blade, to suit
the task at hand.
Use the clamp assembly lock (11) at the back
of the fence to secure the clamp assembly in
position.
Spindle lock button
The spindle lock button (26) prevents the blade
in the saw from rotating.Depress and hold the
spindle lock button while installing,
changing,or removing the blade.
Rotating lower blade guard
The rotating lower blade guard (12) provides
protection from both sides of the blade. It
retracts over the upper blade guard (9) as the
saw is lowered into the workpiece.
Dust bag
The dust bag (15) fits over the dust extraction
port (27). For more efficient operation, empty
the dust bag when it is no more than half full.
This allows better air flow through the bag.
Attaching the side bars (B11)
The side support bars (36) help to support the
material when working with long workpieces.
There are two location holes (37) for a support
bar on either side of the table. Loosen the stop