Operating Instructions - Haussmann Xpert HSMS15A-10-DB Mode D'emploi

OPERATING INSTRUCTIONS

Accessories
The tool is supplied with the following
accessories:
.
Saw blade (fitted)
.
Workpiece clamp
.
Saw blade flange wrench
.
2 Side bars
.
Stabilizer Bar
.
Dust bag
We recommend that you purchase your
accessories in the store from where you
obtained the tool.Use good quality accessories
from the brand recommended by the vendor.
Sales staff will help and offer advice.
Unpacking
Due to modern mass production techniques, it
is unlikely that your HAUSSMANN XPERT Power
Tool is faulty or that a part is missing. If you find
anything wrong,do not operate the tool until
the parts have been replaced or the fault has
been rectified. Failure to do so could result in
serious personal injury.
1) Remove all loose parts from the carton.
2) Remove the packing materials from around
the saw.
3) Using the carrying handle (8) carefully lift
the saw from the carton and place it on a level
work surface.
4) The saw has been shipped with the saw arm
EN
locked in the down position.To release the
saw arm, push down on the top of the saw
arm, pull on the release knob (6), rotate it 45°
and let go, slowly raise the saw arm.
WARNING. Do not lift the saw while holding
on to the guards.Use the carrying handle (8).
Transportation
Lift the mitre saw only when the saw arm is
locked in the down position, the saw is
switched off and the plug is removed from the
power point.
38
Only lift the saw by the carrying handle (8) or
outer castings.Do not lift the saw using the
guard or operating handle (7).
Bench mounting
The saw base has holes in each corner to
facilitate bench mounting.
1)Mount the saw to a level,horizontal bench or
work table and fix the saw to the bench using
4 bolts (not supplied).
2) If desired, you can mount the saw to a piece
of 13 mm or thicker plywood which can be
clamped to your work support or moved to
other job sites and re-clamped.
CAUTION. Make sure that the mounting
surface is not warped as an uneven surface can
cause binding and inaccurate sawing.
Adjusting the three position switch
handle
The switch handle can be positioned in any of
three different orientations, depending on the
cutting situation and user preference.
To reposition the main handle:
1. Release handle clamp (B4).
2. Pull and hold handle rotation release button
(B4).
3. Rotate handle to desired location.
4. Let go over release button to set handle into
place. Release button will retract down only in
one of the three (3) positions.
Note: Power switch can not be actuated
unless release button is retracted down. Do
not attempt to switch tool on between handle
position, damage may occur.
5. Lock the handle clamp.
Adjusting the three-position handle
clamp tension
1. Open handle clamp.
2. Using screwdriver, increase tension by
turning both set screws 1/4 turn to the left,