Safety Warnings - Berker RolloTec Mode D'emploi

GB

1. Safety warnings

Attention: electrical appliances may be installed and fitted by qualified
electricians only.
Any non-observance of the fitting instructions may cause fire or other
hazards.
For the supply of the
of the extension inputs, a power supply unit providing 24 V DC SELV must be
used to ensure safety separation between the primary and the secondary side.
Do not connect this 24 V insert to 230 V extension units: risk of electric
shocks.
Do not connect the
sensor to the RolloTec
risk of electric shocks from 230 V AC transferred into the 24-V-system.
The
window blinds and shutters. Other applications (e.g. roller shutter operation)
may involve hazards caused by moving parts. These hazards must be
excluded by the user by installing additional and suitable safety devices (e.g.
light barriers).
20
®
RolloTec insert 'Komfort' for DC drives
RolloTec ® wind sensor interface and the precipitation
®
system. In the event of faults, there is otherwise the
RolloTec ® System has been developped for the automatic operation of
and the control
GB
Important
Use only blind/shutter motors with limit switches (mechanical or electronic).
Observe the instructions of the motor manufacturers regarding the switch-
over delay and the max. duty cycle (ED) to prevent damage to the motors.
When using an attachment with glass breakage sensor, do not install a
mechanical blind/shutter control switch as an extension unit to prevent
malfunctions.
Please read the operating instructions before installing and using the
device and hand them over to your customer after the installation!
21