Philips FC6148 Mode D'emploi page 8

English
8
preparing for use
installing the charger
1 Attach the charger to the wall as shown in the figure. (Fig. 2)
If you attach the charger to the wall, the space between the screw holes
has to be 12cm.
2 You can also place the charger on a horizontal surface (e.g. a table
or desk) (Fig. 3).
3 Wind excess mains cord around the reel in the back of the charger
and pass the cord through the slot (Fig. 4).
Charging the appliance
Charge the appliance for at least 16 hours before you use it for the first
time.
Tip: If you are not going to use the appliance for a longer period of
time, remove the adapter from the wall socket to save energy.
1 Make sure the appliance is switched off.
2 Put the adapter in the wall socket.
3 Place the vacuum cleaner on the charger (Fig. 5).
- Make sure you place the opening in the back of the vacuum cleaner
on the hook of the charger (Fig. 6).
The charging light flashes to indicate that the appliance
,
is charging (Fig. 7).
The charging light is on continuously to indicate that the appliance
,
is fully charged.
using the appliance
1 Push the on/off slide forwards to switch on the appliance (Fig. 8).
- If you want to use normal power, select speed 1.
- If you want to use high power, select speed 2.
2 Push the on/off slide backwards to switch off the appliance (Fig. 9).