Troubleshooting; Cleaning And Storage - LIVARNO home 898-S-2 Instructions D'utilisation Et Consignes De Sécurité

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

with the solar panel supplied� Do not
connect the floodlight or the solar panel to
any external devices�
When you switch the ON/OFF/AUTO
switch
to "ON" (II) the spotlight remains
16
permanently on� In this position, the locator
light function is deactivated (see Fig� C)�
When you switch the ON/OFF/AUTO
switch
to "OFF" (0) the spotlight
16
remains permanently off (see Fig� C)�
When you switch the ON/OFF/AUTO
switch
to "AUTO" (I) the spotlight is set
16
to AUTOMATIC mode� In this switch
position, the spotlight will switch on/off
according to control settings (for
illumination time, ambient light response
and detection range) (see figure C).
When the spotlight switches off after the set
illumination time, the locator light is
activated� The locator light is only activated
in "AUTO" mode and is deactivated if the
switch is in the "ON" position�
Please note: battery charging via the solar
panel does not depend on the position of
the ON/OFF/AUTO switch
is charged continuously at all times (see Fig�
C)�
Information about functionality: in
twilight or darkness, the solar cell will turn
on the product as soon as the motion sensor
detects movement�
Adjusting the illumination time
Turn the TIME adjuster control
to set the spotlight ON time to the maximum
duration of 60 seconds� Turn the TIME
adjuster control
anticlockwise to set the
13
spotlight ON time to the minimum duration
of 10 seconds (see Fig� E)�
Adjusting ambient light response
The LUX adjuster control
adjust the "response" (i�e� sensitivity) of the
twilight sensor to the ambient light level (see
Fig� E)� Turn the adjuster control clockwise to
have the spotlight switch on at ambient light
38
GB
� The battery
16
clockwise
13
can be used to
12
levels up to as high as 50,000 lux�
Turn the LUX adjuster control
anticlockwise to have the spotlight switch on
at ambient light levels from as low as 5 lux
(see Fig� E)�
Adjusting detection range
Turn the SENS adjuster control
to increase the motion sensor detection
range up to a maximum of 8 metres� The
motion sensor will then activate the spotlight
when motion is detected within a range of 8
metres� Turn the SENS adjuster control
anti-clockwise to reduce the motion sensor
detection range to a minimum of 1 metre�
The motion sensor
9
the spotlight until motion is detected within 1
metre (see Fig� E)�
z Troubleshooting
= Fault
= Cause
= Solution
= The LED solar spotlight does not turn
on�
= The LED solar spotlight is turned off�
= Press the ON/OFF/AUTO switch
(I/0/II) to switch the LED solar
spotlight on (see Fig� C)�
= The light is flickering.
= The battery is almost fully discharged�
= Charge the battery (see section
"Charging the battery")�
z Cleaning and storage
Switch the spotlight
stop using it, store it away or clean it�
Regularly inspect the motion sensor
the solar panel
1
not dirty� Remove any dirt to ensure the
spotlight works correctly�
Keep the spotlight and especially the solar
12
clockwise
14
14
will then not activate
off if you want to
11
and
9
to make sure they are

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

898-w-2

Table des Matières