Charging The Battery; Operation; Troubleshooting - LIVARNO home 1020-B Instructions D'utilisation Et Consignes De Sécurité

tighten the star knob again.
Loosen the Spotlight star knob
„
the angle (see Fig. H).
When the desired position is obtained,
„
tighten the star knob again. If necessary,
use a screwdriver to hold the screw while
tightening the star knob.
Please note: the motion sensor has a field
of view of up to 120°. Make sure that the
motion sensor faces directly towards the
desired detection zone.
Please note: to ensure the solar panel
functions as effectively as possible, make
sure that the surface of the solar panel
not dirty.
Orientation:
The optimum alignment is facing south.
Choose an orientation facing slightly to the
west rather than slightly to the east.
z Charging the battery
The battery is charged in all operating
„
modes. To optimise initial charging, charge
the product while it is turned off.
Please note: the battery is fully charged
after it has been well exposed to sunlight for
7 to 8 hours. The duration of the charging
process depends on the battery's charge
level and the quality of the sunlight.
z Operation
The product can be operated in three
different modes. The operating mode is set
by means of the switch
Please note: the solar panel will turn on the
product in twilight or darkness in the mode
you have set.
Please note: battery charging via the solar
panel does not depend on which mode is
selected. The battery is charged continuously
at all times.
50
GB/IE/NI/CY/MT
to adjust
9
is
2
�
5
Mode 1
Press and hold the switch
„
to switch to "Mode 1".
The Spotlight will light up once and then
„
switch to guide-light function (reduced
brightness).
If the motion sensor detects movement
„
within its range, the Spotlight will light up
at maximum brightness.
After approx. 15 seconds, it switches back
„
to guide-light function.
Mode 2
Press the switch
„
5
"Mode 2".
The light will flicker twice and then switch
„
off.
If the motion sensor detects movement
„
within its range, the Spotlight will light up
at maximum brightness.
After approx. 15 seconds, it will switch off
„
again.
Mode 3
Press the switch
„
5
"Mode 3".
The light will flicker 3 times. The guide-light
„
function (reduced brightness) is then
permanently active. The motion sensor is
inactive in this mode.
Switching off the Spotlight
To switch off the Spotlight, press the switch
„
for a fourth time.
5
z Troubleshooting
= Fault
= Cause
= Solution
= The product fails to switch on.
= The product is switched off.
= Press the switch
product (see section "Operation").
for 3 seconds
5
again to switch to
again to switch to
to turn on the
5