Package Contents; Safety Information - VOLTCRAFT VC271 TRMS Mode D'emploi

4. Package contents

• Digital multimeter
• 2x safety test leads with CAT III protective caps
• 9 V block battery

• Safety information

• Operating instructions (on CD)
Up-to-date operating instructions
Download the latest operating instructions via the link www.conrad.com/downloads or scan the QR code. Follow the
instructions on the website.
5. Safety information
These instructions contain important information on how to use the multimeter correctly. Please
read them carefully before using the multimeter for the first time.
Damage caused due to failure to observe these instructions will void the warranty. We shall not be
liable for any consequential damages.
We shall not be liable for damage to property or personal injury caused by incorrect handling or
failure to observe the safety information! Such cases will void the warranty/guarantee.
• This device was shipped in a safe condition.
• To ensure safe operation and avoid damaging the device, always observe the safety information and
warnings in these instructions.
• Check that the measuring device is functioning correctly with a known source before using it.
• Consult a technician if you are not sure how to use or connect the device.
• Measuring instruments and their accessories are not toys and must be kept out of the reach of children.
• Always comply with the accident prevention regulations for electrical equipment when using the product
in commercial facilities.
• In schools, educational facilities, hobby and DIY workshops, the multimeter must be used under the
responsible supervision of qualified personnel. The same applies when the multimeter is used by people
with reduced physical and mental capabilities.
• Always ensure that the multimeter is set to the correct measurement mode before taking a measurement.
• When using measuring probes without protective caps, measure-
ments between the multimeter and the earth potential must not
exceed the CAT II measurement category.
• When taking CAT III measurements, the cover caps must be
placed on the probe tips (max. length of exposed contacts = 4 mm)
to avoid accidental short circuits. These are supplied with the
device.
39