John Bean T5540 Série Manuel D'utilisation page 4

UPDATING REPORTS
Revision A
First document issue
Cod.: EAZ0033G51A
0
4
Contents
1. General .............................................................. 5
of August 2015
2. Installation and connection ............................... 13
PCN: 15G0231
3. Bead breaking .................................................. 25
4. Clamping wheels .............................................. 29
5. Adjusting the mounting/demounting tool .......... 33
6. Demounting and mounting basics .................... 37
7. Demounting a tyre ............................................ 39
8. Mounting a tyre ................................................. 41
9. Inflating a tyre ................................................... 45
10. Maintenance ..................................................... 51
11. Technical specifications .................................... 53
12.
1.
1.1
Special symbols are used in this manual to facilitate
reading and understanding of pictures and written
instructions:
— Bullets indicate where an action/operation is
1.2
This tyre changer is designed to demount and mount
tyres with a diameter of between 10 and 24".
Tyres can only be inflated on the machine up to 3.3
bars.
Tyres which require a higher pressure must be
inflated in suitable inflating devices (safety cage and
the like).
Clamping ranges for outer and inner clamping are:
Outer clamping
Inner clamping
Accessories
A series of accessories are normally available for the
machine. All the accessories are listed in the attached
document (fig. 0):
ACCESSORIES PLAN
Code: See Fig. 0
• Use the codes in the list for the purchase orders.
Disposing of the unit .........................................
General
Tips for the reader
required.
Safety rules are highlighted in grey.
Arrow indicating important information.
Arrow showing the direction of a
movement.
Scope
Page
55
10 to 24" rim diameter
12 to 24" rim diameter