John Bean T5540 Série Manuel D'utilisation page 14

2
3
14
IMPORTANT!
THEN TIGHTEN THE NUTS "7" WITH A TIGHTENING
TORQUE OF 90 N/m.
D.
Tilt the column backwards. Pull the rod (8) of the
tilting cylinder and connect it to the column with the
pin (9). Lock pin with the split pin (10).
E.
Remove the left side of the machine and attach air
hose (3) (tool movement) to the pedal assembly (11).
Note: For hose connections, see the pneumatic
diagrams supplied in the Spare Parts Manual.
connector (11).
F.
Connect the diameter 8 hose (3, Fig. 2), from the
column to the inflating pedal tap as illustrated.
G.
Refit the column base guard (1) and all of the parts
previously removed.
H.
Secure the tyre changer to the floor.
Note: Hexagonal bar speed adjustment is described
in Chapter 5. Adjusting the mounting/demounting
tool, Fig. 20.