Fulgor Milano F7PBM36S1-L Notice D'installation page 19

• At this point, alignment between the panel and adjacent
cabinets can be adjusted using the alignment brackets
and small brackets [ 7] and [ 8 ].
• Vertical alignment: tighten or loosen the screw in the
brackets to raise or lower the panel [ 9 ].
9
• Depth alignment: working from the inside of the door,
after lifting up the magnetic seal on the handle side and
rotating the plastic covers on the hinge side, adjust the
panel position in the Z-direction by adjusting the shoulder
bolts and setscrews with the 4mm hex key in conjunction
with each other finally locking each mounting position in
place. [ 10 & 11 ].
NOTE
Once the front panel has been adjusted, check that the
gasket has been repositioned correctly to assure the
door/drawer are closing correctly and avoid operational
errors of the unit.
7
8
10
11
EN
17