Tylo SENSE SPORT Notice D'installation page 17

4
Connect the electrical cable (1) to terminal (2) (see Figure
6, Page 4) according to wiring diagram (see The section
called Connection/wiring diagram, Page 6).
Figure 6: Circuit board
1. Electrical cable
2. Terminal for connection of electrical cable
4. Close the cover and tighten the screws (see Figure 5, Page
3).
5.
CAUTION! If all the screws on the back are un-
!
screwed simultaneously, the back plate may
come loose. For this reason, attach the four
brackets to the heater one at a time.
Unscrew the first two screws on the back of the heater and
screw one of the four brackets into place. Repeat the pro-
cedure until all of the brackets are fitted see Figure 7, Page
4.
Figure 7: Attaching the brackets to the heater
1
2
6. Position the bracket screws according to the specified dimen-
sioning see Figure 8, Page 4.
4
3
2
Figure 8: Dimensioning
1. 262 mm
2.
270 mm
3. 532 mm
4. 206 mm
7. Attach the herb bowl/air humidifier (see Figure 9, Page
4).
Figure 9: Fitting the fragrance holder/air humidifier
8. Hang the heater on the screws se Figure 10, Page 4.
Figure 10: Hang the heater up.
1