Publicité
Les langues disponibles
Les langues disponibles
Safety / Start-up
Before use, verify the available mains voltage
corresponds with the operating voltage of the
lamp (230–240 V∼).
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Always unplug from the mains before assembling,
disassembling, cleaning, or if the lamp will not
be used for extended periods.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
The illuminant is not replaceable.
If the illuminant fails at the end of its life, the
entire light must be replaced.
This light is not suitable for dimmer or electronic
switches.
Prevent fire and
injury hazards
RISK OF INJURY! Check every illuminant for
damage immediately upon unpacking. Do not
install the light if the illuminants are defective.
In this case contact the service centre for a re-
placement.
Do not look directly into the light source (light
bulb, LED etc.).
Do not leave the light or packaging material ly-
ing unattended. Plastic film or bags, plastic parts
etc. can turn into dangerous toys for children.
Do not cover the lamp or the mains plug with
objects. Excessive heat can result in a fire.
Never leave the lamp unattended whilst in use.
Safe working
Mount the light so that it is protected from mois-
ture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
10 GB/IE
Never assemble the lamp if you are unfocused
or feel unwell.
Start-up
Mounting the light
Note: When assembling the stand tube
not to damage the mains lead
Unfold the floor lamp.
Model 14107202L or 14107302L:
Screw the upper section of the stand tube
into the bottom section of the stand tube
Carefully pull the mains cable
stand tube
.
4
Screw the standpipe
base
.
6
Plug the power supply into a properly installed
socket.
Model 14107402L:
First screw together the upper stand tube
the centre stand tube
tube
, always clockwise.
4c
Carefully pull the mains cable
stand tube
.
4
Screw the standpipe
base
.
6
Plug the power supply into a properly installed
socket.
Your light is now ready to use.
Switching the lamp on / off
Switch the lamp on or off using the ON / OFF
switch
.
7
Adjusting the reflector
Note: Only adjust the reflector
switched off.
be sure
4
inside the lamp.
5
4 a
.
4 c
out of the
5
clockwise onto the
4
,
4a
and the lower stand
4b
out of the
5
clockwise onto the
4
with the light
1
Publicité
