EHEIM LOOP pro 8000 Mode D'emploi page 15

English
③ Prefilter tub
④ Blue prefilter mat
3. Seal the filter container with the filter container cover.
Installing the pump connection (⌦J)
1. Connect the spiral hose of the pump to the hose connecting piece on the UVC clarifier.
We recommend fastening the hoses with hose clamps.
Connecting the outlet hose (optional)
If required, an outlet hose (Ø 2") can be fitted onto the outlet funnel from the outside.
5. Operation
DANGER! Electric shock!
▶ When the UVC clarifier is fitted, the device's safety distance from the water must be at least 2 m.
DANGER!
▶ Heed the operating manual for the UVC clarifier and the pump, especially the chapters on safety,
commissioning and operation!
1. Place the filter on the pond bank (⌦J).
2. Place the pump on a solid surface as horizontal as possible in the pond so that the filter housing
of the pump is covered by at least 20 cm of water. Pay attention to the maximum pond depth (see
Technical data).
Switching on the pump and UVC clarifier
1. Insert the respective mains plug into the mains socket.
Attention: The pump starts immediately!
Switching off the pump and UVC clarifier
1. Remove the respective mains plug from the mains socket.
6. Maintenance
DANGER! Electric shock!
▶ Before all maintenance work, disconnect the mains plugs of the pump and the UVC clarifier.
DANGER!
▶ Heed the operating manual for the UVC clarifier and the pump, especially the chapters on safety and
maintenance.
CAUTION! Material damage.
▶ Do not use hard objects or aggressive cleaning agents for cleaning.
15