Hilti NURON SC 30WR-22 Mode D'emploi page 28

▶ Prior to each use and before and after prolonged transport, check the
product and the batteries for damage.
Storage
WARNING
Accidental damage caused by defective or leaking batteries !
▶ Always store your products with the batteries removed!
▶ Store the product and the batteries in a cool and dry place. Comply with
the temperature limits stated in the technical data.
▶ Do not store batteries on the charger. Always remove the battery from
the charger when the charging operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind
glass.
▶ Store the product and batteries where they cannot be accessed by
children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the
product and the batteries for damage.
9 Troubleshooting
If a problem occurs, always observe the status indicator of the battery. See
the section headed Status indicators of the Li­ion battery.
If the trouble you are experiencing is not listed in this table or you are unable
to rectify the problem by yourself, contact Hilti Service.
Trouble or fault
LEDs of the battery
show nothing
The on/off button
cannot be pressed,
i.e. the button is
locked.
Running speed sud-
denly drops consid-
erably.
Wood chips are not
transported away;
they drop on to the
base plate.
The battery runs
down more quickly
than usual.
22 English
Possible cause
Battery defective
Not a fault (safety func-
tion).
Battery is discharged.
Saw advance pressure
is too high.
The chip ejector channel
is blocked.
Battery condition is not
optimal.
Action to be taken
▶ Contact Hilti Service.
▶ Press the switch-on
interlock.
▶ Charge the battery.
▶ Reduce advance
pressure and switch
the power tool back
on.
▶ Clean the ejector.
▶ Replace the battery.
2264108
*2264108*