Hilti NURON SC 30WR-22 Mode D'emploi page 15

and the cutting width of the blade must be wider than the thickness of
the riving knife.
▶ Adjust the riving knife as described in this instruction manual.
Incorrect spacing, positioning and alignment can make the riving knife
ineffective in preventing kickback.
▶ Always use the riving knife except when plunge cutting. The riving
knife must be replaced after plunge cutting. The riving knife causes
interference during plunge cutting and can create kickback.
▶ For the riving knife to work, it must be engaged in the workpiece.
The riving knife is ineffective in preventing kickback during short cuts.
▶ Do not operate the saw if the riving knife is bent. Even a light
interference can slow the closing rate of a guard.
2.3 Additional safety instructions
Personal safety
▶ Never tamper with or modify the product or accessories in any way.
▶ Always hold the power tool with both hands on the grips provided.
Keep the grips dry, clean and free from oil and grease.
▶ Wear ear protectors. Exposure to noise can cause hearing loss.
▶ Respiratory protection must be worn if the power tool is used without
a dust removal system for work that creates dust.
▶ Operate the power tool only together with the safety devices that
belong to it.
▶ Improve the blood circulation in your fingers by relaxing your hands
and exercising your fingers during breaks between working.
▶ The power tool is not intended for use by inexperienced persons
who have received no special training.
▶ Keep the power tool out of reach of children.
▶ Do not switch the product on before it is at the workplace.
▶ Remove the battery before storing or transporting the power tool.
▶ Do not work overhead with the product.
▶ Do not attempt to brake the product by applying lateral pressure to
the saw blade.
▶ The path of the saw must be free of obstructions. Do not saw into
screws, nails etc.
▶ Do not touch the clamping flange or the clamping screw while the
power tool is running.
▶ Never press the drive spindle lock button while the saw blade is
rotating.
▶ Never direct the power tool toward persons.
▶ Adjust the pressure applied to the saw blade and the material being
cut so that the blade does not stall, possibly causing kickback.
▶ Avoid overheating the tips of the saw blade teeth.
▶ When cutting plastic, melting of the plastic should be avoided.
*2264108*
2264108 English 9