Hilti NURON SC 30WR-22 Mode D'emploi page 26

WARNING
Risk of collision when making bevel cuts! Collision between saw blade
and guide rail.
▶ Set the saw on the guide rail with the correct groove engaging the rib of
the rail. The saw blade will otherwise collide with the guide rail.
1. Secure the guide rail with 2 screw clamps.
2. Set the cutting angle for bevel cuts.
3. Set the saw on the guide rail with the 1°­50° groove mark on the rib of
the guide rail.
4. Switch the tool on. → page 19
5. Advance the saw along the guide rail to make the cut through the
workpiece.
7 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance
tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning
agents containing silicone as these can attack the plastic parts.
• Use a dry, clean cloth to clean the contacts of the product.
Care of the Li­ion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully
using a dry, soft brush.
• Avoid unnecessary exposure of the battery to dust and dirt. Never
expose the battery to high levels of moisture (e.g. by being dipped in
water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery.
Isolate it in a non-flammable container and consult Hilti Service.
• Keep the battery free of extraneous oil and grease. Do not permit dust
or dirt to accumulate unnecessarily on the battery. Clean the battery
with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-
applied grease from the contacts.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning
agents containing silicone as these can attack the plastic parts.
20 English 2264108
*2264108*