Maintenance - Panasonic RR-US300 Mode D'emploi

■
Precautions for listening with the Headphones or Earphones
• Do not play your headphones or earphones at a high volume. Hearing experts advise against continuous extended play.
• If you experience a ringing in your ears, reduce volume or discontinue use.
• Do not use while operating a motorized vehicle. It may create a traffic hazard and is illegal in many areas.
• You should use extreme caution or temporarily discontinue use in potentially hazardous situations.
• Even if your headphones or earphones are the open-air type designed to let you hear outside sounds, don't turn
up the volume so high that you can't hear what's around you.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent
type recommended by the manufacturer. Dispose
of used batteries according to the manufacturer's
instructions.
• Excessive sound pressure from earphones and
headphones can cause hearing loss.
• Listening at full volume for long periods may damage
the user's ears.
Be sure to use the supplied or recommended
headphones or earphones.
Based on EN 50332-2:2003
1) Maximum output voltage (earphone output):
2) Wide band characteristic voltage (earphones):

Maintenance

Clean this unit with a dry and soft cloth.
• If the unit becomes too dirty, wring a cloth moistened in water, wipe the dirt with it and clean with a dry cloth.
• Do not use solvents including benzine, thinner, alcohol, kitchen detergent, a chemical wiper, etc. This might
cause the exterior case to be deformed or the coating to come off.
This product may receive radio interference
caused by mobile telephones during use. If such
interference is apparent, please increase separation
between the product and the mobile telephone.
■
When discarding of/transferring this unit
When "Erase" or "Format" are performed on this unit or
a computer, the data in the internal memory cannot be
played back but it is not completely erased.
For security reasons, to ensure that the data has been
completely deleted, use a commercially available data
erasure software, or format the unit and then record
something else such as a soundless environment to
overwrite the internal memory.
■
Data when requesting repairs
150 mV
When the unit is repaired, the internal memory and
75 mV
settings may be returned to the factory settings.
ENGLISH
35
35