Starting The Ups On Battery; Ups Shutdown - Eaton 9130 Guide D'installation

Starting the UPS on Battery

NOTE Before using this feature, the UPS must have been powered by utility power with
output enabled at least once.
NOTE Battery start can be disabled. See "User Settings" in the UPS user's guide.
To start the UPS on battery:
1. Press the
panel display illuminates and shows a status of "UPS starting...".
The UPS cycles through Standby mode to Battery mode. The
indicator illuminates solid. The UPS supplies power to your
equipment.
2. Check the UPS front panel display for active alarms or notices
besides the "UPS on Battery" notice and notices that indicate
missing utility power. Resolve any active alarms before continuing.
Refer to "Troubleshooting" in the UPS user's guide.
Check the UPS status from the front panel to view the active
alarms. Correct the alarms and restart if necessary.
3. Press the

UPS Shutdown

To shut down the UPS:
1. Press the
The UPS starts to beep and shows a status of "UPS off pending...".
The UPS then transfers to Standby mode, and the
turns off.
NOTE Releasing the
operating mode.
2. Switch off utility power where the UPS is connected.
EATON 9130 (9910-E15/E16) UPS Installation Guide for IBM
button on the UPS front panel until the UPS front
ESC
button until the start screen appears.
button on the front panel for three seconds.
button before three seconds returns the UPS to its original
®
S
Applications 164201783 Rev 2
OPERATION
indicator
23