Isdn Terminal At The Internal Up0 Port - Auerswald COMmander 6000 Notice D'utilisation

ISDN Terminal at the Internal U
Connection possibilities:
• System phones COMfortel 1200/1400/1600/2600 (firmware version 1.6A or later)
• System phones COMfortel 1100/1500/2500/2500 AB (firmware version 4.4E or later)
• COMfortel DECT 900 Bases for COMfortel DECT 900C/900 (U
• ISDN phones in accordance with the Euro ISDN Standard (DSS1)
• ISDN PC controllers in accordance with the Euro ISDN Standard (DSS1)
If the terminals and the PBX have a short
distance to each other, connect a single
COMfortel 1200/1400/1600/2600 system
phone directly to the RJ-45 socket of the
internal U port. For all other ISDN
P0
terminals or two system phones per port
you require a U /S
P0 0
If the distance between PBX and terminal
is greater, cables and wall sockets must
be laid fixed. A socket wall is connected
with the terminal clamps of the U
Caution: Terminals integrated in the wall sockets are destroyed and can damage
the device.
• Contrary to the S
already integrated in the terminals (COMfortel 1200/1400/1600/2600 or U
• Remove terminals which have already been integrated in the wall sockets for use at the
U port.
P0
Note: You do not need an ISDN wall socket if you use a U
Adapter can be mounted on the wall or it can be connected to the PBX via the two screw
terminals on the back.
COMmander 6000/R/RX - Instructions V11 11/2018
Port
P0
Adapter.
port as shown in the figure.
P0
port, do not equip a line at the U
0
/S Adapter necessary)
P0 0
internal U port
P0
IAE/UAE8
port with terminals. These are
P0
/S Adapter. The U
P0 0
Installation
/S Adapter).
P0 0
/S
P0 0
69