Conglom Transform QL114 Manuel De L'utilisateur page 8

Installation (continued)
INSTALLING THE FAUCET
Carefully take out all the parts of the faucet assembly .
- Insert the faucet shank (2), hose end (4) and faucet outlet (3) through the holes of the base plate (5)
and sink accordingly .
- From underneath, slide the rubber gasket (6) and faucet shank nut (7) over the end of the faucet
shank (2), then tighten faucet shank nut (7) by hand until it is snug.
- Connect the hose end (4) to the faucet outlet (3). Push the faucet head (1) into the faucet neck.
Install the counterweight (8) a couple of inches from the bottom of the hose on the side closest to
the faucet head (1). There should be no slack in the hose and it should retract freely.
- Connect the water supply lines (not supplied) to the faucet.
Faucet shank (2)
Base plate (5)
Rubber gasket (6)
Faucet shank nut (7)
Counterweight (8)
QL114
Faucet head (1)
Faucet outlet (3)
8
Sink
Hose end (4)