Conglom Transform QL114 Manuel De L'utilisateur page 10

Installation (continued)
MOUNTING THE UTILITY SINK
- Carefully place a bead of sealant all around
the top of the cabinet (A).
- Ease the sink (B) into the cabinet (A). Ensure
that it is placed evenly and is centered on
the cabinet (A). Wipe off any excess sealant.
Use masking tape to hold the sink (B) in
place until the sealant dries .
PLACEMENT
- Push the cabinet (A) against the wall. Position cabinet as desired. If required, level it by adjusting
the four leveling feet and checking the alignment of the sink (B) using a carpenter's level.
IMPORTANT: Secure the cabinet to the wall using hardware best suited for your wall type. Failing to
do so could result in property damage or personal injury.
Use silicone sealant to seal the sink to the wall and any adjacent surfaces to keep those surfaces dry.
Failing to do so could result in moisture damage.
DRAINAGE
- The tailpipe (not supplied) previously installed to the drain can now be connected to your
household plumbing. In some cases, your household plumbing will have to be modified to ensure
proper drainage. If so, please consult a licensed plumber to complete needed modifications.
SUPPLY LINES (NOT INCLUDED)
- Connect the supply lines to your home's water
supply as per manufacturer's instructions .
- Open the hot and cold water supply valves and
check to make sure they have been installed to
appropriate inlet ports . Check for leaks . Run hot and
cold water uninterrupted for about one minute to
remove any residue from the lines .
QL114
B
A
10