Entering Company Data - Waeco AirCon ServiceCenter ASC5300G Notice D'utilisation

ASC5300G
7.5

Entering company data

The company data is printed out with every service log.
1. In the basic menu, use the cursor keys  or  to select "Other
selections":
2. Press ENTER to confirm.
3. Use the cursor key  to select "Service".
4. Press ENTER to confirm.
5. Enter the password "3282".
6. The company data is shown in the third line of the display (6).
You can enter five lines, each with up to 20 characters.
The display shows the number of lines of company data after the
message "Enter company data" ("01" to "05").
Use the cursor keys  or  to select the line of company data you
want.
7. Use the keypad (7) and the cursor keys to enter the data.
To switch between upper and lower case, press the Info key
To delete a character, briefly press the C key.
To delete the current line, press and hold down the C key.
8. Press ENTER to confirm.
9. Press STOP. The set data is activated.
10. Press STOP again to access the standby menu.
EN
Short selection
Free selection
Other selections
ENTER-OK
Initial start-up
.
75