Waeco AirCon ServiceCenter ASC5300G Notice D'utilisation page 117

ASC5300G
Problem
The display shows
"Not enough UV.
Add!"
The display shows
"Not enough oil.
Add!"
The display shows
"Max. filling time
exceeded!
Carry on?"
The display shows
"External tank empty or
closed valve.
Check!"
The display shows
"Change the equipment
drier filter!
Go on?"
The display shows
"Change the vacuum pump
oil!
Go on?"
The display shows
"Printer not in line!
Carry on?"
The display shows
"Error 01"
The display shows
"Error 02"
The display shows
"Error 09"
EN
Cause
This message appears dur-
ing the filling process if there
is not enough UV additive in
the container to finish the
process.
Message that appears during
the filling process if there is
not enough fresh oil in the
container to finish the pro-
cess.
Message that appears during
the filling process if the set
amount of refrigerant cannot
be filled.
Message that appears at the
start or during the filling of
the internal refrigerant con-
tainer if the set refrigerant
quantity cannot be attained.
This message appears when
you switch on the
AirConServiceCenter.
This message appears when
you switch on the
AirConServiceCenter.
Message indicates a printer
fault.
Refrigerant was added
before draining was com-
pleted.
The air conditioning system
is leaking. There is still refrig-
erant in the air conditioning
system.
Low pressure connector not
connected to the flush con-
tainer during flushing.
Troubleshooting
Remedy
Fill the UV additive container.
Top up the fresh oil container
with a suitable oil type.
Check that
AirConServiceCenter con-
nections are not blocked.
Check if the external refriger-
ant container still contains
enough refrigerant or if the
valves of the external refrig-
erant container are open.
Change the internal filter as
soon as possible (see chap-
ter "Changing the dryer filter"
on page 103).
To continue press ENTER.
Change the vacuum pump oil
as soon as possible (see
chapter "Changing the vac-
uum pump oil" on page 108).
To continue press ENTER.
Check if there is paper in the
printer.
Check if the printer is
switched on (yellow LED
must light up constantly).
Check that the cover is
closed properly.
Repeat the draining proce-
dure; do not interrupt it this
time.
Fix the leak.
Connect low pressure hose
to the flush box and open
valve.
117