How To Wire This Unit; Installation; Installation Precautions; Installation Example (For Installation Beneath Seat) - Clarion DVH943 Mode D'emploi

How to Wire This Unit

Perform the settings and
connections in the order
Throughout the process of wiring this
indicated by the drawing
unit, disconnect the negative (–) terminal
below.
of your automobile's battery, and leave it
disconnected until completely finished.
Handling wires while the terminal is
connected could result in dangero
electrical shock or injury if an scccidental
short circuit shoud occur.
1
CeNET Cable
• To connect a CeNET cable, hold it with the
connector facing as shown, and insert
securely.
• When disconnecting a CeNET cable, grasp
the slide cap and squeeze gently.
2
Optical Digital Cable
• Insert the black connector securely into the
digital signal input connector until it locks.
The cable clip can be used to secure up to
two optical digital cables.
• When disconnecting a optical digital cable,
squeeze the tabs at the right and left sides
of the connector, and pull gently.
Note:
• The optical digital cable should not be bent
with a gentle arc radius of 1.5 cm or less. If
it is bent sharper than this, the performance
of the cable will be greatly reduced and the
cable may be damaged.
3
RCA Pin Cable
• When connecting an RCA pin cable, be
sure to confirm the source of the
connection first.
4
[RESET] switch
• Following completion of wiring, press the
[RESET] switch to return to default
settings.
12
DVH943
CAUTION
CeNET connector
Sliding cap
CeNET cable
Note:
• Route the CeNET cable with plenty of extra room
so that the connector will not become
disconnected accidentally.
Optical Digital cable
(black connection)
Cable clip
Squeeze right/
left tabs
Note:
• Always turn the main [POWER] switch [OFF]
before connecting or disconnecting digital fiber-
optic cables.

7. INSTALLATION

Installation Precautions

CAUTION!
• Install correctly, using only the screws
supplied as accessories. Using other
screws may result in damage or injury.

Installation Example (for installation beneath seat)

1. Use the supplied screws (M4x8) to attach the accessory mounting bracket to the sides of the unit.
• The main unit's case has been provided with 3 screw holes on either side. Select the screw
holes required for your installation conditions.
2. Position the unit on the floor mat, then mark and open holes in the floor mat so they are aligned
with the mounting bracket's holes.
3. Press the accessory canoe clips from the underside upward through the mat and into the mounting
bracket holes.
Mounting
screws
Mounting bracket
Canoe clips
Case Case
Damage
8 mm max.
Mounting
bracket
Mounting
screws
Floor mat
Canoe clips
13
DVH943