DAITEM SH402AX Notice D'installation page 93

iMPoRtAnt
• Some functions are only available with versions 2.0.0 or later
(press
• the operating differences with former ranges are described in the compatibility booklet
available in the Daitem installers section at www.daitem.co.uk.
Following
a command
Commands Disarm
Arm
Armed Partial 1 or 2
Disarm Group
Arm Group
Arm Presence mode
Door bell
Disarm under duress
System Disarm
status query
Arm
Armed Partial 1 or 2
Disarm group
Arm Presence mode
Alarms Intrusion when
presence mode armed
Entry delay
Fire alarm
Changing User test mode
siren modes
Installation mode
User mode
on the control panel keypad to check the version).
Vocal message
"bip, off"
"bip, armed"
"bip, armed Partial 1" or "bip, armed Partial 2"
"bip, off": if all the groups allocated to the siren are disarmed
"bip, off Group X": if only part of the groups allocated to the siren
are disarmed
"bip, armed": if all the groups allocated to the siren are armed
"bip, armed Group X": if only part of the groups allocated to the
"bip, armed Presence"
"ding, dong"
"bip, off"
"bip, off"
"bip, armed"
"bip, armed Partial 1" or "bip, armed Partial 2"
"bip, off Group X"
"bip, armed Presence"
"bip, bip, bip, bip, intrusion Group X"
"bip, bip, bip, bip, Protection active"
loud sounding for 15 s then "Fire_alarm" (alternating)
"bip, test_mode"
"bip, installation_mode"
"bip, useR_mode"
93
siren are armed
GB