Performing A Real Test; Maintenance; Fault Indications - DAITEM SH402AX Notice D'installation

GB

6. Performing a real test

Testing triggering when there is an attempt to remove the siren
iMPoRtAnt: the sounding level of the siren
can cause hearing disorders. the necessary
precautions must therefore be taken before
testing siren triggering.

7. Maintenance

7.1 Fault indications

The control panel supervises and identifies the siren. It monitors the state of the:
• power supply,
• radio link,
• tamper contact.
If a fault is memorised the control panel issues a voice message to indicate the fault
following a system command (see § Fault indications in the control panel installation
manual).
1. Loosen the siren locking screw.
2. Open the siren.
3. Check triggering:
• of the siren,
• of the control panel,
- of the telephone dialler.
4. Issue an Off order.
104