THOMSON GKT440SI Série Guide D'installation Et D'utilisation page 34

1 / INSTALLING YOUR APPLIANCE
•
A A d d j j u u s s t t t t h h e e h h o o b b c c o o n n n n e e c c t t i i o o n n s s : they are
located underneath the knobs (Fig. 04) .
— Proceed one tap at a time.
— Remove the knobs and the gaskets by
pulling them up.
- Switching from
butane/propane gas
-
With a small flat-head screwdriver, s s c c r r e e w w i i n n
a a l l l l t t h h e e w w a a y y the brass (yellow) burner power
screws (Fig. 05), i i n n a a c c l l o o c c k k w w i i s s e e d d i i r r e e c c t t i i o o n n . .
-
Replace the gaskets and the knobs, paying
careful attention to their direction and
ensuring that the knobs are pushed in all the
way.
- Switching from butane/propane gas to
natural gas
-
Unscrew the brass (yellow) burner power
screws (Fig. 05) , using a small flat-head
screwdriver, t t u u r r n n t t w w i i c c e e c c o o u u n n t t e e r r c c l l o o c c k k w w i i s s e e . .
-
Replace the knob.
-
Light the burner in maximum heat mode,
then turn down to reduced heat mode.
-
Remove the knob again, then turn the
burner power screws c c l l o o c c k k w w i i s s e e until it
reaches the lowest possible setting that does
not extinguish the flame.
-
Replace the gasket and knob.
-
Make several attempts to shift from the
maximum flow rate to the minimum: : t t h h e e f f l l a a m m e e
s s h h o o u u l l d d n n o o t t g g o o o o u u t t ; if it does, unscrew the
burner power screw so as to obtain good
flame retention during these position
switches.
-
Reposition the burner heads, burner covers
and pan supports on the hob.
natural gas to
Fig. 04
Burner power
adjustment screw
Fig. 05
34
Manette
Robinet
Bague
d'étanchéité
Tap axis