THOMSON GKT440SI Série Guide D'installation Et D'utilisation page 32

1 / INSTALLING YOUR APPLIANCE
Gas supplied by tank or
•
cylinder (butane/propane)
For your safety, you must choose from the
three following connection options:
— Connection with a rigid pipe made from
copper and with screw-on mechanical
connectors (G1/2 gas standard mark). Make
the connection directly to the end of the
elbow fitted on the appliance.
— Connection with a wavy metal hose
(stainless steel) with screw-on mechanical
connectors whose service life is unlimited
(Fig. 01).
— Connection with a reinforced flexible
rubber hose with screw-on mechanical
connectors whose service life is 10 years
(Fig. 02).
A
Sealing washer (not provided)
B
Adaptor (not supplied)
C
Clamp (not provided)
In an existing system, a soft pipe fitted with
clamps whose service life is five years may be
used. It is necessary in this case to use an
adaptor without forgetting to fit a sealing
washer between the adaptor and the hob's
elbow. (Fig. 03).
Tip
You can obtain the adaptor and the sealing
washer from your After-Sales Service
Department.
Warning
Screw on the adaptor with a torque
not exceeding 25 N.m.
@ Q
Fig. 01
@ Q
Warning
All soft pipes and hoses whose
service life is limited must have a maximum
length of two meters and must be
accessible along their entire length. They
must be replaced before the end of their
service life (indicated on the pipe).
Regardless of the means of connection
chosen, ensure that the connection is air
tight, after installation, with soapy water.
32
Fig. 02 Fig. 03
A
B
C