Installing Your Appliance; Proper Positioning; Flush Mounting - THOMSON GKT440SI Série Guide D'installation Et D'utilisation

1 / INSTALLING YOUR APPLIANCE

Fig. 01
• • PROPER POSITIONING
Your appliance shoud be built in the surface
of a support cabinet that is a minimum of
three cm thick, made of a material that resists
heat or that is covered with such a material.
So as not to disturb movement of cooking
utensils, there should not be to the right or
left or back any obstacle within 30 cm of the
hob.
if a horizontal divider wall is positioned under
the hob, it should be placed between 10 cm
and 15 cm away from the top of the work top.
In any event, do not store aerosol cans or
containers under
compartment that may exist under the hob
(See " Safety Recommendations " chapter).
• •

FLUSH MOUNTING

To ensure that the hob and the work top are
leaktight, glue the seal provided in the front
pocket before installing the hob:
Follow the diagram (Fig. 01) .
— Remove the pan supports, the burner covers
and burner heads, noting their positions.
pressure in any
Width
Cut 56 cm
cabinet
standard
Cut 26,5 cm
cabinet
standard
Dimensions 71 cm
total
above
the work 31 cm
top
Dimensions 55,4 cm
total
below
the work 26 cm
top
— Turn the hob over and carefully place it on
top of the opening in the cabinet so asnot to
damage the knobs and spark plugs.
— To ensure a tight seal between the housing
and the work top, glue the foam seal a a l l o o n n g g
t t h h e e e e x x t t e e r r i i o o r r e e d d g g e e o o f f t t h h e e h h o o u u s s i i n n g g (Fig. 02 ).
Housing
Seal
29
APPLIANCE
Depth Thickness Model
49 cm According 60 cm
to cabinet
49 cm According 30 cm
to cabinet
52,2 cm 5 cm 60 cm
51 cm 5 cm 30 cm
47 cm 5,1 cm 60 cm
47 cm 5,1 cm 30 cm
Fig. 02
EN