Electrolux EN3450COW Notice D'utilisation page 31

Problem
The compressor op-
erates continually.
Water flows on the
rear plate of the re-
frigerator.
Water flows into the
refrigerator.
Water flows on the
ground.
The temperature in
the appliance is too
low/high.
If your appliance is still not working prop-
erly after making the above checks, con-
tact the After Sales Centre. You can find
the list at the end of this manual.
7.1 Replacing the control unit
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the con-
trol unit. Contact your Service Center.
Possible cause
The unit is defective.
The temperature is not set
correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The food temperature is
too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
7.2 Closing the door
1.
2.
Solution
Refer to "Replacing the
control unit".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the food temperature
decrease to room tempera-
ture before storage.
Decrease the room temper-
ature.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher/lower tempera-
ture.
Clean the door gaskets.
If necessary, replace the defective
door gaskets. Contact the After Sales
Service.
ENGLISH 31