Projecting; Turning On The Projector - Sony CPJ-A300E Mode D'emploi

Projecting

If the bulb does not
light up
If you press POWER
again just after turning
it off, the bulb will not
light up. This is because
of the characteristics of
the bulb and is not a
malfunction. In this
case, wait for a while
and press POWER
again. The bulb will
light up.
Notes
• Wait until the
projector is warmed
up. It will take about
one minute until the
projected plane
appears.
• Do not press POWER
while the LAMP
indicator is flashing.
Doing so will cause
malfunction of the
projector.
If the ON/STANDBY
indicator keeps
flashing
Turn off the power and
disconnect the mains
lead. Wait for more
than three seconds.
Then reconnect the
mains lead and turn on
the power again.
Mirror
FOCUS
LOCK
Front stand

Turning on the projector

1
Press the POWER switch on the front to turn on the
power.
When the power is turned on, the ON/STANDBY
indicator lights in red.
2
Press POWER of the control panel.
The ON/STANDBY indicator turns green. The
LAMP indicator starts flashing.
The bulb lights up and the projected plane appears.
3
If necessary, adjust the position of the projected
plane using the stand.
1 Unlock the stand.
Control panel
POWER
ON/STANDBY LAMP
POWER LASER LINK
FUNCTION
VOL
RESET
Side stands
continued
11
Projecting -GB