Product Description - IKEA FROSTIG SC100/17 Mode D'emploi

ENGLISH
• Unpack the appliance and check if there
are damages on it. Do not connect the
appliance if it is damaged. Report possi-
ble damages immediately to the After
Sales Service (refer to "Service"). In that
case retain packing.
• It is advisable to wait at least four hours
before connecting the appliance to allow
the oil to flow back in the compressor.
• Adequate air circulation should be
around the appliance, lacking this leads
to overheating. To achieve sufficient ven-
tilation follow the instructions relevant to
installation.
• Wherever possible the back of the prod-
uct should be against a wall to avoid
touching or catching warm parts (com-
pressor, condenser) to prevent possible
burn.
• The appliance must not be located close
to radiators or cookers.
• Make sure that the mains plug is accessi-
ble after the installation of the appliance.
Service
• Any electrical work required to do the
servicing of the appliance should be car-
ried out by a qualified electrician or com-
petent person.
• This product must be serviced by the Af-
ter Sales Service, and only genuine spare
parts must be used. The service numbers
are listed in the Service information.

Product description

Carefully read the operating instructions
before using the appliance.
Environment Protection
This appliance does not contain gasses
which could damage the ozone layer, in ei-
ther its refrigerant circuit or insulation mate-
rials. The appliance shall not be discarded
together with the urban refuse and rubbish.
The insulation foam contains flammable
gases: the appliance shall be disposed ac-
cording to the applicable regulations to ob-
tain from your local authorities. Avoid dam-
aging the cooling unit, especially at the rear
near the heat exchanger. The materials
used on this appliance marked by the sym-
bol are recyclable.
6