Setting The Temperature - Dometic Waeco CoolFreeze CF-80 Manuel D'utilisation

_CF-80_110.book Seite 35 Montag, 20. September 2010 10:40 10
Note
I
If you wish to operate the cooler from the AC mains, set the battery
monitor to the "LOW" position.
Caution – Danger from excessively low temperature!
a
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
Press the "ON/OFF" button (fig. 2 1, page 3) for between one
and two seconds.
The "POWER" LED lights up.
The display (fig. 2 5, page 3) switches on and shows the
current cooling temperature.
Note
I
The temperature displayed is that of the middle of the interior.
The temperatures elsewhere can deviate from this temperature.
The cooler starts cooling the interior.
Note
I
When operating with the battery, the display switches off auto-
matically if the battery voltage is low. The LED "POWER" flashes
orange.
6.6

Setting the temperature

Press the "SET" button (fig. 2 4, page 3) once.
Use the "UP +" (fig. 2 6, page 3) and "DOWN -" (fig. 2 7,
page 3) buttons to select the cooling temperature.
The cooling temperature appears in the display for a few
seconds. The display flashes several times and then the current
tempera-ture is displayed again.
Operation
35