Assembly; Fitting The Loop Handle; Fitting The Trimmer Head; Fitting The Trimmer Guard And Trimmer Head - Husqvarna 322L Manuel D'utilisation

Fitting the loop handle

• Position the loophandle on the shaft. Note that the
handle must be mounted between the arrows on the
shaft.
• Fit the screw, securing plate and wing nut as shown in
the diagram.
• Tighten the wing nut.

Fitting the trimmer head

WARNING! When fitting the cutting
!
attachment it is extremely important that
the raised section on the drive disc/
support flange engages correctly in the
centre hole of the cutting attachment. If
the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.

ASSEMBLY

Fitting the trimmer guard and
trimmer head
• Fit the correct trimmer guard (A) for use with the
trimmer head. Hook the trimmer guard/combination
guard onto the fitting on the shaft and secure with the
bolt (L).
• Fit the drive disc (B) on the output shaft.
• Turn the output shaft until one of the holes in the drive
disc aligns with the corresponding hole in the gear
housing.
• Insert the locking pin (C) in the hole to lock the shaft.
• Screw on the trimmer head/plastic blades (H) counter
clockwise.
• To dismantle, follow the instructions in the reverse
order.
H
H
–
English 11