Bosch Zamo Notice Originale page 35

Cause
– Faulty adapter
– Adapter has no connection
to the measuring tool
Display shows "----", meas-
urement not possible
Measuring range exceeded
(20 m)
or
poor measuring conditions
Fitting the Adapter (see figures E, H,
J)
– Remove the cover cap (9) from the measuring tool.
– Attach the adapter to the laser measure so that it clicks into
place.
– To remove the adapter, press the release buttons (10) and
take off the adapter.
– Reattach the cover cap to the measuring tool.
Bosch Power Tools
English | 35
Corrective measure
Send the adapter to the after-
sales service.
Clean the contacts.
If the adapter still cannot con-
nect to the measuring tool
after you have done this, send
the adapter to the after-sales
service.
Keep the measuring range
<20 m and read the notes on
the measuring range
1 609 92A 454 | (14.06.2018)