Maintenance - Ryobi WS722 Manuel D'utilisation

WARNING:
When servicing, use only identical Ryobi replacement
parts. Use of any other parts may create a hazard or
cause product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions.
CALIFORNIA PROPOSITION 65
WARNING:
This product and some dust created by power sanding, sawing, grinding, drilling, and other construction activities may
contain chemicals, including lead, known to the State of California to cause cancer, birth defects, or other reproductive
harm. Wash hands after handling.
Some examples of these chemicals are:
• lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products and,
• arsenic and chromium from chemically treated lumber.
Your risk from exposure to these chemicals varies, depending on how often you do this type of work. To reduce your
exposure, work in a well-ventilated area and with approved safety equipment, such as dust masks that are specially
designed to filter out microscopic particles.
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.

MAINTENANCE

NOTE: ILLUSTRATIONS START ON PAGE 12
CLEANING THE RIP AND MITER GUIDES
During use, the rip and miter guides will become dirty
preventing the guides from sliding smoothly. It is important
to clean the saw often.
ADJUSTING LOCKING LEVER ASSEMBLY
See Figure 23, page 16.
Over time, the rip guide may become loose. If the rip guide
does not lock securely to the saw table, adjustments may
be required.
 Unplug the saw and remove the rip guide.
 Using a hex key, loosen the cam screw.
 Turn the cam to tighten as desired.
NOTE: An arrow is visible on the roller. The wider end of
the arrow is the tighter end of the adjustment. The smaller
end of the arrow is the looser end of the adjustment.
 When the desired adjustment is made, tighten the cam
screw securely.
CLEANING THE SAW
 Unplug the saw.
 Remove the guides and bevel table from the saw.
 Using a small brush and/or water, clean each piece
thoroughly removing any trapped debris.
 Remove the overflow drain and empty waste water into a
bucket. Do not allow the water to splash onto the ground
or around the machine.
 Rinse the machine thoroughly.
 Discard the waste water in accordance with local
regulations.
 Replace the overflow drain. Tighten securely.
 Dry off the tool.
11 — English