HumanTechnik A-2409-0 Mode D'emploi page 10

When supplied from the factory, all
portable RF receivers are set to
channel 0. It is only necessary to set
units to other channels if you have
several different users operating
units in the same building.
Set the required channel by using a
small screwdriver to turn the channel
selector switch, which is located on the
right of the receiver, to the required
channel number. Use a small screw-
driver to adjust this switch.
All transmitters and receivers must be
set to the same channel.
2. Transmission signal detection
The portable RF receiver converts the various transmission signals into
different sequences of vibration and lamp signals.
Telephone:
Vibration
Door I:
Vibration
Door II:
Vibration
Baby monitor:
Vibration
10 English
Telephone LED lights
Door LED lights
Door LED flashes
Baby LED lights
Fig. setting the correct radio channel.
Operation –
1. Switching on the unit
Set the on/off switch to on. The portable
RF receiver is now ready to operate.
After the unit has been switched on,
each of the indicator lamps lights up
briefly in succession and the receiver
vibrates three times. This forms part of a
self-test of the unit and lets you know
that it is functioning correctly.