Publicité
Les langues disponibles
Les langues disponibles
Adjusting the fastening torque
► 1. Adjusting grip 2. Ring
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjusting
the fastening torque as follows.
1.
First remove the battery cartridge from the tool.
2.
Loosen the screws securing the lamp cover.
3.
Rotate the ring in the front of the tool by hand so
that a hole can be seen below the ring.
4.
Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjusting ring
rotates and becomes visible in the hole. And then
remove the battery cartridge.
1
2
3
4
8
► 1. Angle head 2. Adjusting ring 3. Ring 4. Scale
5. Adjusting grip 6. Hole for adjusting grip 7. Yellow
line 8. Compression spring
5.
Use an optional adjusting grip to adjust the fasten-
ing torque. Insert the pin of the adjusting grip into
the hole in the front of the tool. And then, turn the
adjusting grip clockwise to set a greater fastening
torque, and counterclockwise to set a smaller
fastening torque.
6.
Align the edge of the adjusting ring with your
desired number on the fastening torque scale.
7.
Align the yellow line with your desired number on
the fastening torque scale.
8.
Insert the battery cartridge and be sure that a fas-
tening torque has been set up by using a fastening
torque tester.
9.
Tighten the screws to secure the lamp cover and
then rotate the ring in front of the tool until the ring
is locked.
1
2
5
6
7
8 ENGLISH
NOTE:
•
Numbers on the fastening torque scale is a
guideline to set up your desired fastening
torque.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket or screw bit
There are different types of sockets or bits for some
models depending on applications. Choose and install a
correct socket or bit for your application.
Installing or removing socket
1
2
3
► 1. Socket 2. Hole 3. Pin
To install the socket, push it onto the square drive of the
tool with one hand by depressing a pin on the square
drive with another hand until it locks into place. To
remove the socket, simply pull it off depressing the pin
on the square drive.
Installing or removing bit
1
2
► 1. Screw bit 2. Sleeve
Publicité
