Quality Espresso FUTURMAT PALANCA Mode D'emploi page 9

Only Authorized Serviced Technicians are qualified to provide the maximum guarantee with regard to service
and original replacement parts.
Official Technical Service.
CAREFULLY READ THE RISKS AND SAFETY GUIDELINES IN THIS SECTION
● This machine does not have components for the user to make repairs. It can only be manipulated
by personnel from Authorized Technical Service.
● Before starting any maintenance procedure, cut off the electricity either through the general
installation switch or disconnecting the electricity supply cable.
● Children do not recognize the dangers of machines, thus they should be kept out of their reach and
they should be prevented from handling the machines.
● Individuals with diminished physical, sensory or mental capacities, or who are untrained, should not
operate this machine without the supervision of qualified personnel.
● To clean the machine, follow the instructions in this manual.
● To ensure the optimum functioning of the machine, request that only Original Replacement Parts are
used, which can be supplied by authorized Technical Service or the manufacturer.
The manufacturer accepts no responsibility in the case of failure to comply with the valid legislation in
the location where the machine is installed.
INSTRUCTIONS
To turn on the gas burner, follow these instructions:
st
1 Open the general gas key or valve if it is bottled gas.
nd
2 Turn the gas switch (2) to the left (as indicated in Fig. C) and press. Turn on the burner pressing the
button (1) and maintaining it for 10 seconds. Release slowly.
If you want to maintain the pressure in the boiler with the gas burner alone, turn the general switch
(2I, as indicated in the general instruction manual drawing according to the machine model) to
position ("2") which will disconnect the resistance.
At the end of the work day shut off the gas supply by turning the gas switch (2) to the right to position
•
( ).
MAINTENENCE
Keep the areas immediately surrounding the burner clean and dust-free.
Once a week, with the burner turned off and cooled, clean the flame outlets as well as the areas around the
thermocouple and the pressure switch regulator injector with a brush.
This will keep the passage clear, as it tends to become obstructed by residue from the gas flow.
It is not necessary to grease the stopcocks.
ATTENTION: THIS PROCEDURE SHOULD BE PERFORMED BY AN AUTHORIZED INSTALLER
USER MANUAL
Request Original Replacement Parts, Installation and Maintenance from
9