Milwaukee M18 HCC75 Notice Originale page 12

3.
10. 11 Nm
GB
1. Use a wrench or pliers to remove the blade
nuts and remove the blade bolt.
2. Remove the retaining ring and pull out
the pin from one of the blades.
3. NOTE: Take notice of the blade orientation so the new
blades can be installed the same way. The blades should
be oriented so the at sides contact and the bevels face
away from each other, like a pair of scissors.
4. Carefully remove the blade.
5. Install the new blade in the same orientation.
Check that the cutting tools can move freely.
To avoid injury and damage, never immerse the tool, removable
battery or charger in liquid or allow liquid to penetrate them.
The ventilation slots of the machine must be kept clear at all times.
The device contains hydraulic uid. Hydraulic uids pose a hazard
to groundwater. Uncontrolled draining or improper disposal is
punishable by law.
The device should be serviced every six to twelve months, depen-
ding on usage.
You can nd out more about service intervals via the ONE-KEY app.
English
Deutsch
10
9. 1 Nm
6. Slide the pin through the blade and bracket.
Replace the retaining ring.
7. Repeat steps 2 to 6 for the other blade.
8. Insert the blade bolt.
9. Thread the inner blade nut onto the
blade bolt and tighten to 1 Nm.
10. Thread the outer blade nut onto the blade bolt.
Holding the inner blade nut motionless, tighten the
outer blade nut to 11 Nm to lock the nuts together.
Service and repair work may only be carried out by authorised
specialist workshops.
Use only Milwaukee accessories and Milwaukee spare parts. Should
components need to be replaced which have not been described,
please contact one of our Milwaukee service agents (see our list of
guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on the
label and order the drawing at your local service agents or directly
at: Techtronic Industries GmbH, Max-Eyth-Straße 10, 71364 Win-
nenden, Germany.