Milwaukee M18 HCC75 Notice Originale page 10

3. When the cut is complete, pull the release trigger to open the
blades. (3)
Pull the slider switch into the locking position. (4)
ACTION IN THE EVENT OF FAULTS
• The cable can be broached and become live, always inform the
network operator, stop the cutting process, and initiate suitable
protective measures
• Always ensure that the device is and will stay disconnected from
the power supply before approached and touching the device
• press and hold the reset button until the cutter opens completely
GB
• check the battery capacity
• check the material and material thickness against the technical
data
• In case of a defect of the cable cutter, it must (Neu übersetzen
"Bei Verdacht des Schneidens eines spannungsführenden Kabels
muss der Kabelschneider...") be checked in an approved specialist
workshop
English
Deutsch
8
3
JAMMED BLADES
Dirt and debris can cause the blades to become jammed together
after a cut
• Press and hold the release trigger to ensure the tool has reset.
• Remove the battery pack.
• While holding in the release trigger, use a rubber mallet to tap
the blade retainer until the blades open.
• Clean any dirt and debris from the blades before starting another
cut.
CUTTING TIPS
• Do not attempt to make angled cuts as it will damage the
workpiece and blades.
• Lay the cable cutter on the cable, with its cutting edge at right
angle, up to the inner cutting end.
• Cut clean material to extend the blade life. Wipe dirt and debris
from material and blades before beginning the cut.
4