Selecting Sirius Source; Listening To Sirius; Selecting A Sirius Channel Directly - Pioneer CD-SB10 Mode D'emploi

SIRIUS tuner
b CLEAR button
Press to cancel the input number when 0 to
9 are used.
c 0 to 9 buttons
Press to directly select the desired channel
or preset tuning. Buttons 1 to 6 can operate
the preset tuning.

Selecting SIRIUS source

% Press SRC to select SIRIUS.

Listening to SIRIUS

1
5
1 SIRIUS band indicator
2 SIRIUS channel number indicator
3 SIRIUS preset number indicator
4 SIRIUS channel select setting indicator
Shows what channel select setting has been
selected. CH is displayed when
Channel number is selected, and CAT is dis-
played when Category is selected.
I.R is displayed during the Instant Replay
mode.
5 SIRIUS channel name
Shows the channel name of broadcast
channel.
% Select a SIRIUS band.
Press BAND.
2 3 4
# Band can be selected from SR-1, SR-2 or
SR-3.
% Select a channel.
Push MULTI-CONTROL left or right.
# If you push and hold MULTI-CONTROL left or
right, you can increase or decrease channel num-
ber continuously.
# You can also perform tuning from a desired
channel category. (Refer to Selecting a channel in
the channel category on page 13.)
Notes
! It may take a few seconds before you can hear
anything while this system acquires and pro-
cesses the satellite signal.
! When you change the channel, the channel
name is displayed, followed by the category
name.

Selecting a SIRIUS channel directly

When using the remote control, you can select
the SIRIUS channel directly by entering the de-
sired channel number.
1 Press DIRECT.
Channel number input display appears.
2 Press 0 to 9 to enter the desired channel
number.
# You can cancel the input number by pressing
CLEAR.
3 Press DIRECT.
The SIRIUS channel of entered number is
selected.
# After entering the number input mode, if you
do not perform an operation within about eight
seconds, the mode is automatically canceled.
Section
02
11
En