Section 4; Before Use; Driveline - breviglieri t76sr - 105 Manuel D'utilisation Et D'entretien

macchine agricole

SECTION 4

Instructions for use

4.1 BEFORE USE

Before he sets the machine at work, the operator must have read and understood all parts of this manual and particularly
Before beginning work, make sure that the machine is in order, that the lubricating oils are at the right level and that all parts
subject to wear and deterioration are fully efficient. Also make sure that the guards are correctly positioned.
Adjustments and operations required to prepare the machine for work must always be carried out with the machine off

4.1.1 DRIVELINE

The driveline is a mechanical component. When it is operating it can be a source of danger to the physical well-being of
those who work with it. Take the greatest care when carrying out operations that involve the driveline. Carefully read the
instruction manual supplied with the driveline. If you have doubts about the way it operates, if it is without its shields, worn
or broken, replace it with a new driveline that possesses the same characteristics and bears the «CE» mark.
If the length must be adapted, work with the utmost care so as to keep the telescopic tubes coupled to the maximum extent.
With the exception of length adaptation, it is forbidden to modify the driveline. If
this is necessary, contact the Manufacturer. Take the greatest care when inserting
the driveline. Make sure that it is well locked on both the tractor's PTO and on the
machine. Also comply with the indications in the instruction manual supplied with
each driveline. Make sure that the driveline shield, fastened with the relative chains,
is free to turn without obstruction. Also check the guards on both the tractor and
implement. If they are not in a perfect condition, they must be immediately replaced
with new protections. It is very important for the protective guards to overlap the
driveline shields by at least 5 cm on both sides.
When the driveline is fully extended, in all work conditions, the telescopic tubes must
overlap to at least 1/3rd of their length (A Fig. 4).
When the driveline is fully inserted, the play must be at least 4 cm (B Fig. 4). Contact
the Manufacturer's Technical Service if this is not possible.
Before engaging the PTO, make sure that its rotation speed corresponds to the rate for which the machine has been desi-
gned.
76
t sr
WARNING
«Section 2» about safety.
DANGER
and blocked.
DANGER
DANGER
Never modify or adapt the driveline in any way.
CAUTION
- 26 -
Fig. 4