Operation Telephone; Setting The Ring Volume; Flash (R); Last Number Redial - Topcom Clip Phone 101 Mode D'emploi

Clip Phone 101

3 OPERATION TELEPHONE

3.1 Setting the ring volume

The ring volume switch is located on the right side of the phone. You can choose either high
low or OFF . Switch to the desired volume level. When you choose OFF
will not ring when a call comes in.

3.2 Flash (R)

Press the Flash button to activate certain services, e.g. 'Call Waiting' (this service is only available if
provided by your telephone provider), or to transfer phone calls when you are using a telephone
exchange (PABX).

3.3 Last number redial

When you want to call back the last dialled telephone number, press the Redial button as soon as you
have picked up the receiver. The number will be dialled automatically.

3.4 Memory numbers

You can program 15 telephone numbers (of max. 16 digits) in the memory under the memory locations
0..9 or M1..M5.

3.4.1 Programming a memory number

• Press the Memory button.
• Enter the telephone number.
• Press the Memory button again.
• Press the memory location 0..9 (numerical buttons) or M1..M5.

3.4.2 Calling a memory number

• Pick up the receiver and press M1, M2, M3, M4 or M5; or press the Memo button first, followed by
the memory location 0..9.
• The programmed number will be dialled automatically.

4 SETTINGS

4.1 Setting a language
This phone can show the display text in 5 different languages. To set the desired language, take the
following steps:
• Press and hold the Erase and Up button simultaneously.
• Release both buttons and press the Up button to scroll through the menu until "SET LANGUAGE"
appears on the display.
• Press the Erase button to confirm.
• Use the Up or Down button to set the correct language.
• Press the Erase button to confirm your choice.
15
,
the phone