Installation; Buttons - Topcom Clip Phone 101 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Clip Phone 101

1 INSTALLATION

You can use batteries or an AC adaptor to activate the telephone display. When you install the batteries,
the telephone lines at the back of the phone have to be disconnected.
To insert the batteries, take the following steps :
• Use a screwdriver or any other flat tool to open the battery compartment.
• Put four 1,5V (AAA) batteries inside the battery compartment.
• Close the battery compartment carefully.
Note : When the "Battery empty"
To install the phone, you have to do the following :
• Connect one end of the telephone cable to the Clip Phone 101 and the other end to the receiver.
• Connect one end of the telephone line to the back of the phone "LINE" and the other end to the
telephone line wall socket.

2 BUTTONS

1
Numerical buttons
2
Memory button
3
Memo button
4
Recall button
5
Erase button
6
Down button
7
Up button
8
Pause button
9
Mute button
10 Flash button
11 Redial button
12 Direct Memory button M1
13 Direct Memory button M2
14 Direct Memory button M3
15 Direct Memory button M4
16 Direct Memory button M5
17 Ring volume switch
18 Volume switch
symbol appears on the display, the batteries need to be replaced by new ones.
14

Publicité

Table des Matières
loading

Table des Matières