Installation - JUKI LK-1942ZA5050 Manuel D'utilisation

III. INSTALLATION
❶
❷
❸
❺
❹
[Removing the carrier bolt]
Remove carrier bolt ❶ which is used to fix the main
body of the sewing machine.
[Removing the fixing knob]
Remove fixing knob ❷ of the needle thread heat cut-
ter.
[Installing the eye protection cover]
Be sure to install and use eye protection cover ❸ .
[Installing the thread stand]
1) Assemble the thread stand, and set it in the hole
in the top right corner of the machine table.
2) Tighten locknut ❹ to fix the thread stand.
3) When ceiling wiring is possible, pass the power
cord through spool rest rod ❺ .
– 4 –